Skip to content
Workshop: repairs and experiments

Why keyless entry doesn't always work: "key not detected" and how to find the cause

Published 19.11.2026
Contents 8
  1. In short
  2. How the car looks for the key
  3. Why it doesn't always work
  4. "Key not detected", but found in another pocket
  5. The key and Bluetooth earbuds in one pocket
  6. What can jam keyless entry
  7. Tracking down the fault step by step
  8. Scope of this article

Why keyless entry doesn't always work and how to find the cause. In this article:

  • how the car looks for the key and why this link is weak by design;
  • why the car says "key not detected", yet finds the key in another pocket;
  • why the key stops working next to Bluetooth earbuds;
  • what can jam keyless entry;
  • how to track down the fault step by step.

How car keys work in general is covered in the article can you find a lost car key with a 433 MHz receiver.

⚠ Even when the car "can't see" the key, every smart key has a backup: a metal blade hidden inside the key opens the door, and the engine starts if you hold the key against a marked spot in the cabin. Your owner's manual says where that spot is in your car. Find it in advance, not out in the cold.

In short

What happensMost likely causeWhat to do
works on and off, more often fails in the coldthe key battery is running downreplace the battery
"key not detected", but found in another pocketthe key is blocked by your body, a phone or metalkeep the key on its own, in the pocket on the door side
stops working in the same pocket as earbudsmagnets and metal of the case next to the key's receiving coilput the key and the earbuds in different pockets
fails only in one car parkradio interference nearbyunlock with the key button, check that the car actually locked
can't detect the key while the phone is on a wireless chargerthe charger is noisy near the frequency the car uses to call the keyswitch the charger off and try again
fails with both the main and the spare keya fault on the car side: antenna, handle, module, batterycheck the car battery, then a scan tool diagnosis
only one handle doesn't unlockthe touch sensor or antenna in that handleclean dirt or ice off the handle, then a garage

How the car looks for the key

Keyless entry is a conversation that the car always starts:

  1. You touch the handle or press the start button.
  2. Antennas in the door handles, the cabin and near the boot send out a weak low-frequency field, most often 125 kHz. The key hears it only within 1–2 m.
  3. The key wakes up, checks that it is its own car calling, and replies on a much higher frequency: 433 or 868 MHz in Europe, 315 MHz in the US.
  4. The car checks the reply and, from how strong its field is at the key, works out where the key is: by a door, in the cabin or in the boot.

The weak point is step 2. The 125 kHz field is made weak on purpose, so that the key answers only near the car. Close to the antenna it fades very quickly: twice as far means a field roughly eight times weaker. So there is little margin, and anything that weakens the field a little or stops the key from hearing it gives you "works on and off". The key's reply on 433 MHz carries much further and usually causes fewer problems.

Why it doesn't always work

The key battery

The most common cause. A weak battery hits keyless entry first: the key hears the car's weak field less well and replies more quietly. The buttons still work: they don't need to hear the car, the key simply transmits on its own.

Signs:

  • worse in the cold, better in the warm: a cold battery gives a lower voltage;
  • the car shows "key battery low" or asks you to hold the key against the marked spot;
  • the spare key works more reliably.

The battery type is printed on the battery itself and in the manual; most often it is a CR2032, sometimes a CR2025, a CR2450 or another. Buy a fresh one from a known brand: cheap and old batteries sag under load.

The key has "fallen asleep"

Some modern keys have a motion sensor: a key lying still stops answering even its own car after half a minute to a few minutes, depending on the make. Manufacturers do this to protect the car from relay theft while the key sits at home. Picking the key up or pressing a button wakes it.

Some keys also have a manual power-saving mode that switches keyless entry off. It is turned on by a button combination, different for each make, and it sometimes gets turned on by accident in a pocket.

Where the key is

The human body is mostly water, and water absorbs the 433 and 868 MHz radio waves the key replies on. The body hardly affects the 125 kHz field, but the car may not hear the reply from a key in a back pocket pressed against the seat, or in the pocket on the side away from the door, even though the key is right there. More on this in the section about another pocket.

What is next to the key

The key hears the car's field with a small coil on a ferrite core. Metal and magnets nearby detune it, and the key becomes "hard of hearing":

  • a phone, especially one with a wireless charging coil;
  • a metal cigarette case, a wallet with metal mesh, a power bank, a laptop;
  • magnetic holders, earbud cases, magnetic phone wallets.

More on earbuds in the section below.

The car battery

When the car battery is weak, the modules become unreliable, and keyless entry is one of the first things to fail. Some cars go into a power-saving mode after a long time parked and switch keyless entry off partly or fully, so as not to drain the battery: then only the key button or only the driver's door unlocks the car.

The door handle

A handle usually holds both an antenna and a touch sensor. Dirt, ice, water or a thick glove stop the sensor from feeling your hand. If only one handle won't unlock and the rest work, the cause is most likely in it: the sensor, the antenna or the wiring to it.

"Key not detected", but found in another pocket

This is normal, and usually the key isn't broken. The car calls the key with several antennas, and each covers only its own area. In the cabin there are spots between them where the field is weaker. A pocket is only a few centimetres, but that is enough for a field that drops several times over a short distance, and for a body standing between the key and the antenna.

What changes when you move the key:

  • the distance to the antenna. Antennas sit in fixed places: in the handles, the centre console, under the rear seats, near the boot. A pocket closer to the console or the door means a stronger field;
  • your body between the key and the car. When you are seated, the reply from a key in the door-side pocket is heard better than one in the pocket on the passenger side. Outside it's the same: a key behind your back is heard less well;
  • what is next to it. In one pocket the key sits next to a phone or earbuds, in another it is on its own;
  • which way the key faces. The coils in the key are designed for any position, but with a half-flat battery the difference between positions becomes noticeable.

If the key gets "lost" more and more often, including in pockets where it used to work, that points to the battery, not the pocket.

The key and Bluetooth earbuds in one pocket

Bluetooth itself is most likely not to blame. It works at 2.4 GHz, far from the frequencies the car and the key use. The earbud case is what gets in the way:

  • magnets. The case has strong neodymium magnets that hold the earbuds and the lid. A magnet next to the ferrite core of the key's coil can saturate the ferrite, the coil is detuned, and the key hears the car's field less well. That is why some manufacturers write in the manual: don't carry the key with magnetic key rings or near devices that create a magnetic field;
  • metal and the battery. The case's battery and metal parts can weaken the field near the key;
  • a wireless charging coil. Cases with wireless charging have their own coil with a ferrite plate that soaks up part of the field.

The earbuds in your ears get in the way less than the case in your pocket: their magnets are small.

A magnet doesn't damage the key for good: as soon as the earbuds are in another pocket, everything works. If the key fails even away from the earbuds, the cause is something else, most often the battery.

How to check that the case is to blame:

  1. Put the key alone in a pocket and lock and unlock the car several times.
  2. Put the earbud case next to it and repeat in the same pocket at the same distance.
  3. If the car consistently can't see the key with the case but can without it, carry them in different pockets.

What can jam keyless entry

In the car itself

  • A wireless phone charger. Qi chargers work at roughly 100–200 kHz, close to the 125 kHz the car uses to call the key. Factory chargers usually pause while the car is looking for the key; aftermarket ones don't always do that. A typical case: the phone is on the charger, the key is next to it, and the car can't detect the key when you try to start.
  • Cheap and add-on devices. USB chargers in the cigarette lighter, 230 V inverters, dash cams, LED bulbs in place of ordinary ones. Their switch-mode power supplies are noisy over a wide band of frequencies.
  • Fitted equipment. An extra alarm, remote start, immobiliser bypass modules wired in badly.

The check is simple: switch off everything that was added separately and try again. If it works, turn the devices back on one at a time.

Around the car

  • Transmitters and power lines nearby. A car park next to a powerful transmitter, a substation or a high-voltage line. Then keyless entry fails only in that spot, and a few dozen metres away everything is fine.
  • Other devices on the same frequencies. Wireless doorbells, weather stations, barrier gates and sensors all use 433 and 868 MHz. A faulty device that transmits non-stop can drown out the key's reply nearby.
  • Jammers. Thieves use them so that the car doesn't lock when the owner presses the button. Using jammers is illegal. The defence is simple: after locking, check that the car really locked — the mirrors folded, the lights flashed, the handle doesn't open.

A sign of outside interference is that the fault is tied to a place: in one car park the car can't find the key, in another it works with the same key.

Tracking down the fault step by step

  1. Start the car the backup way. Hold the key against the marked spot and start the car. If it starts, the key's transponder and the immobiliser are fine; the problem is in how the car hears the key at a distance.
  2. Try the spare key. The spare works and the main one doesn't — it's the main key. Neither works — it's the car.
  3. Replace the key battery, even if the buttons still work.
  4. Empty your pocket of everything except the key and try again: phone, earbuds and magnetic items go elsewhere.
  5. Switch off the wireless charger and everything added separately. Try again.
  6. Try in another car park. If it works there, the cause is interference at the first one.
  7. Work out what exactly fails: all handles or one, the boot, the start button. One handle or only the boot means the antenna or sensor in that spot.
  8. Check the car battery. After the car has stood for a few hours, a voltmeter across the terminals should show at least 12.4–12.5 V. Noticeably less means the battery is weak or something drains it while parked.
  9. Scan tool diagnosis. The keyless entry module stores fault codes: antenna open circuit, key not responding, handle sensor. A scan tool shows which antenna or handle has failed. This is a job for a garage.

Scope of this article

This article contains no key codes, no radio packet structure and no ways to get around the car's security. We explain why keyless entry fails and how to find the cause. Repairing the car's modules, antennas and wiring is a job for a garage.